Re: [microblaze-uclinux] mb_vanilla can't run kernel image

[John Williams <jwilliams@xxxxxxxxxxxxxx>]

Hi Aaron,

Aaron Rasmsusen wrote:
> John Williams wrote:

>> I've attached a compressed image.bin that resulted from the fresh make 
>> I did yesterday - can you try it on your board and see if it works 
>> (don't forget to gunzip it first!). Might help us to isolate the cause 
>> of your difficulties.
> 
> I tried this a few times, and it never worked very well.

[snip]

> I'm going to try this on some different boards when I get time later 
> today or tomorrow.

Hmm, it sounds like you've got some sick hardware.  Time to review the 
basics:

Which mbvanilla platform are you building?  Have you changed anything at 
all - address map, MHS parameters, UCF file, ...

What are your exact ISE and EDK version numbers (including service packs 
etc)

What revision Insight board (1 or 3)?

Any unusual jumper settings?  All IO banks should be at 3.3V

I'm rebuilding a clean mbvanilla_net bitfile, I'll post it to the list 
when it's done.  Can you try that on your board, see if it will work 
with the kernel image I sent yesterday?

Cheers,

John


___________________________
microblaze-uclinux mailing list
microblaze-uclinux@itee.uq.edu.au
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/