RE: [microblaze-uclinux] uClinux boot problem

[SERRANO Fabrice <fabrice.serrano@xxxxxxxxx>]

-----Message d'origine-----
De : Yasushi SHOJI [mailto:yashi@atmark-techno.com]
Envoye : dimanche 6 juin 2004 11:51
A : microblaze-uclinux@itee.uq.edu.au
Objet : Re: [microblaze-uclinux] uClinux boot problem


At Sat, 05 Jun 2004 22:16:26 +1000,
John Williams wrote:
[...]
> >>Calibrating delay loop...
> > 
> > 
> > I just tested suzaku with msrset/msrclr enabled, suzaku stopped the
> > same place. I haven't dig any deeper to see what's causing this.
> > obviously interrupt is not working as John said in the other mail.
> 
> Sorry for the obvious question - but have you enabled the new MSR 
> instructions in the hardware build (and platgen tweak) - as per below?

ok, that was it.  Thanks John.

Fabrice, how's yours?

regards,
--
            yashi
--------------------------
	Thanks for your advises, John and Yashi.
 I'm trying to find the error (it seems to be a problem with the
interruptions like you said) because I've tryed several kernel
configurations (with and without MSR, hardware divider...) and I get the
same problem.

So I'll verify the interruption and maybe ask you other questions :)

bye,

Fabrice
###########################################

This message has been scanned by F-Secure Anti-Virus for Microsoft Exchange.
For more information, connect to http://www.F-Secure.com/
___________________________
microblaze-uclinux mailing list
microblaze-uclinux@itee.uq.edu.au
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/