[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
AW: [microblaze-uclinux] microblaze uclinux and SysACE+CF
Hi Claudio,
Yes, it is possible and we had a system like that running before we switched over to the ppc.
The driver is included in cvs under drivers/block/xilinx_sysace.
We wrote our own bootloader which copies the kernel into sdram.
You have to figure out the kernel startposition on your cf.
We copied it raw without filesystem to a special partion on cf and mounted another partion as root filesystem.
All the bootloader does is that it copies the kernel from the raw partion into sdram.
Use dd to copy the kernel to the raw partion.
Good luck
Jan and Eric
> -----Ursprüngliche Nachricht-----
> Von: owner-microblaze-uclinux@itee.uq.edu.au
> [mailto:owner-microblaze-uclinux@itee.uq.edu.au] Im Auftrag
> von Claudio Lanconelli
> Gesendet: Mittwoch, 15. Dezember 2004 10:11
> An: microblaze-uclinux@itee.uq.edu.au
> Betreff: [microblaze-uclinux] microblaze uclinux and SysACE+CF
>
>
> Hi folks,
>
> I'm new to uclinux and Microblaze, I have few questions.
>
> Does anyone tried to access a CF card with systemace chip on
> uclinux? Is the driver available? Is it possible to mount the
> CF as root filesystem? Is it possible to boot from CF?
>
> Regards,
> Claudio Lanconelli
>
> ___________________________
> microblaze-uclinux mailing list
> microblaze-uclinux@itee.uq.edu.au Project Home Page :
http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
___________________________
microblaze-uclinux mailing list
microblaze-uclinux@itee.uq.edu.au
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/