[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [microblaze-uclinux] "Value too large to represent" error during FPGA 'libs' build

To: <microblaze-uclinux@xxxxxxxxxxxxxx>
Subject: RE: [microblaze-uclinux] "Value too large to represent" error during FPGA 'libs' build
From: "Kevin Somervill" <kevin.m.somervill@xxxxxxxx>
Date: Fri, 28 Jan 2005 10:02:14 -0500
Importance: Normal
In-reply-to: <41F96AC8.4070105@itee.uq.edu.au>
Reply-to: microblaze-uclinux@xxxxxxxxxxxxxx
Sender: owner-microblaze-uclinux@xxxxxxxxxxxxxx

Hey John,

|EDK allows you to insert '_' characters to space out the digits, like 
|0x80000_0000.

No matter what you do, I think it may complain about 0x80000_0000.
Unless you have a 36-bit architecture ;)

/ks

___________________________
microblaze-uclinux mailing list
microblaze-uclinux@itee.uq.edu.au
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/

References:
- Re: [microblaze-uclinux] "Value too large to represent" error duringFPGA 'libs' build
  - From: John Williams

Prev by Date: [microblaze-uclinux] mutt in uClinux-dist
Next by Date: Re: [microblaze-uclinux] error updating bitstream (porting uClinux_auto to Xilinx ML401)
Previous by thread: Re: [microblaze-uclinux] "Value too large to represent" error duringFPGA 'libs' build
Next by thread: [microblaze-uclinux] mutt in uClinux-dist
Index(es):
- Date
- Thread