[microblaze-uclinux] login issue when booting

[mcnernbm@xxxxxxxxxxxxxxxxx]

When booting the uclinux on a memec
v2p board I get the results below.  But once it hits the login part
I can not login.  I have tried root as the username and pass and jsut
root as used and no pass and I can nto get it to login.  Also there
is the one fail listed and not sure if that is causing me a problem or
not.  Also the only thing I changed when I built the kerneal is I
disable the ethernet and networking stuff and the gpio driver and I also
changed the MDM to the generic rom selection.  All other option I
left alone.

zone(0): 8192 pages.ash device at locati
zone(1): 0 pages.rch for id:(00 00
zone(2): 0 pages.pe(2)rning: dev (
CPU: MICROBLAZErch for id:(00 
Kernel command line:e
MBVanil
CFI: Found
Console: xmbserial on UARTLitero00 00)
interleave(2) type(1)
Page-cache hash table entries: 8192
(order: 3, 32768 bytes)
POSIX conformance testing by UNIFIX
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer
Society NET3.039
Microblaze UARTlite serial driver version
1.00
ttyS0 at 0xffff2000 (irq = 1) is a Microblaze
UARTlite
Starting kswapd
RAMDISK driver initialized: 16 RAM disks
of 4096K size 1024 blocksize
uclinux[mtd]: RAM probe address=0x800c58fc
size=0xb2000
uclinux[mtd]: root filesystem index=0
VFS: Mounted root (romfs filesystem)
readonly.
Freeing init memory: 32K
Mounting proc:
Mounting var:
Populating /var:
Running local start scripts.
Mounting /etc/config:
Populating /etc/config:
flatfsd: Nonexistent or bad flatfs (-43),
creating new one...
flatfsd: Failed to write flatfs (-43):
No such device
flatfsd: Created 3 configuration files
(142 bytes)
Setting hostname:

uclinux-auto login:

THanks for the help
Brett