Re: [microblaze-uclinux] login issue when booting

[John Williams <jwilliams@xxxxxxxxxxxxxx>]

Hi Brett,

mcnernbm@notes.udayton.edu wrote:
> 
> I also noticed in places it says the default is username is root and 
> password is uClinux but that still does not work it just asks for a 
> username and password again and again with no luck

So at least you got past the romfs/init problem?  Was it just the 
console issue that was fixed yesterady, or was there something else as well?

> When booting the uclinux on a memec v2p board I get the results below. 
>  But once it hits the login part I can not login.  I have tried root as 
> the username and pass and jsut root as used and no pass and I can nto 
> get it to login.  Also there is the one fail listed and not sure if that 
> is causing me a problem or not.  Also the only thing I changed when I 
> built the kerneal is I disable the ethernet and networking stuff and the 
> gpio driver and I also changed the MDM to the generic rom selection. 
>  All other option I left alone.

check vendors/Xilinx/uclinux-auto/Makefile, search for "root", you'll 
see where the default password is set.  It should be root and root....

> zone(0): 8192 pages.ash device at locati
> zone(1): 0 pages.rch for id:(00 00
> zone(2): 0 pages.pe(2)rning: dev (

[snip]

this concerns me a bit - your console output is all chopped up and 
mangled, is this how it looks on your terminal (what terminal SW are you 
using?), or is it just a problem in copying it into your email?

Regards,

John
___________________________
microblaze-uclinux mailing list
microblaze-uclinux@itee.uq.edu.au
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/