[microblaze-uclinux] auto-config, Spartan 3 (xc3s400)

["Carr, Vincent" <Vincent.Carr@xxxxxxxxxxx>]

Hi,

I posted last week regarding getting uClinux running on the Spartan 3
eval board (xc3s400).

I've made some progress since using the auto-configured Microblaze
platform for uClinux but have hit a stumbling block.

Here's what I've done so far (basically following the steps in the
auto-config README):

1) Checked out the uclinux source and distribution environment.
2) Downloaded the uclinux BSP and built a microblaze core for the above
hardware using the Xilinx EDK.
3) I've taken the generated auto-config.in file and copied it across to
the ~/uClinux-dist/linux-2.4.x/arch/microblaze/platform/uclinux-auto
directory.
4) Now from the ~/uClinux-dist I run "make menuconfig"

Now here is where I have some questions.

The readme says to "Simply enter the kernel configuration menu
(Customize Kernel Settings), then 
save and exit. It is not necessary to make any changes, simply entering
the 
menu causes the new auto-settings to be detected. Finally, build the
kernel as per normal."  

When I run "make menuconfig" I have two menu options available
		Vendor/Product Selection
		Kernel/Library/Defaults Section

I've tried various different combinations of menus but I do not appear
to be able to proceed to building the kernel.

Do I need to select an option from the "Vendor/Product selection" menu
to be able to proceed with the auto config?

Am I missing something obvious here - I've attached the auto-config.in
file.

Thanks in advance,
Vincent Carr

Attachment: auto-config.in
Description: auto-config.in