Re: [microblaze-uclinux] auto-config, Spartan 3 (xc3s400)

[John Williams <jwilliams@xxxxxxxxxxxxxx>]

Hi Vincent,

Carr, Vincent wrote:

> The readme says to "Simply enter the kernel configuration menu
> (Customize Kernel Settings), then 
> save and exit. It is not necessary to make any changes, simply entering
> the 
> menu causes the new auto-settings to be detected. Finally, build the
> kernel as per normal."  
> 
> When I run "make menuconfig" I have two menu options available
> 		Vendor/Product Selection
> 		Kernel/Library/Defaults Section
> 
> I've tried various different combinations of menus but I do not appear
> to be able to proceed to building the kernel.

I was being a bit brief when I wrote that README.  From this top menu, 
choose the "Vendor/Product" submenu, and select "Xilinx" as the vendor, 
and "uclinux-auto" as the product/board.

Then, return to the top menu, and go into the "Kernel/Library/Defaults" 
submenu.  There, select the box that says "Customise Kernel Settings". 
Then, exit the menu sytem, and say "yes" when it asks to save your changes.

The kernel config menu will then launch.  Here, just choose exit, and 
say "yes" to save changes, and you will return to the command line.  Do 
"make dep all" and you will be on your way.

The uClinux-dist menu mechanism and structure can be a little confusing 
the first few times you use it, but soon it will become almost automatic 
for you.

Hope this helps,

John

___________________________
microblaze-uclinux mailing list
microblaze-uclinux@itee.uq.edu.au
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/