[microblaze-uclinux] XMD Crashing using NuHo reference design

["Jim Law" <jlaw@xxxxxxxxxxxxx>]

Hi all,

Have:

NuHo S3-2000 board
Parallel-IV cable
ISE 7.1.03i installed in c:\xilinx7\
EDK 7.1.02i installed in c:\edk7\
ChipScope Pro 7.1.03i
uClinux BSP V1.00a 16mar2005 - unzipped into c:\edk_user_repository\
Dave Banas' NuHo_S3-2000_uClinux_Rel2005062301.zip  - unzipped to 
e:\uClinux_try\

Followed the Quick Start instructions from Dave Banas:
- copied the VHD files as described (noted that there is a newer 
emc_common_v2_00_b\hdl\vhdl core in the directory - ignored this)
- launched XPS, opened the system.xmp, "download the bitstream" built and 
downloaded fine
- can see and talk to the bootloader from HyperTerm fine

Problem:
- when I launch XMD, it crashes
- I note that the connect command has some extra switches after the "cpunr 
1"  switch.  The full line is:
 "connect mb mdm -cable type xilinx_parallel port LPT1 -debugdevice cpunr 
1 -pfs1 port 0 type s"
- after "Loading MHS File", it shows me the Adress Map twice, and then gives 
a Windows report.

Tried changing the XMD options to Sim - runs ok (but not what I need <g>)
Changed the settings back - same results.

Thots? anyone?

Jim Law
Iris Power Engineering

___________________________
microblaze-uclinux mailing list
microblaze-uclinux@itee.uq.edu.au
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/