RE: [microblaze-uclinux] USB support with uClinux

["Raj Nagarajan" <raj.nagarajan@xxxxxxxxxx>]

Hi Arthur,

USB cable is supported in EDK7.1. Check the following..

1. Your ISE installation is 7.1 SP1 +
2. If using EDK 7.1 or SP1, ensure the USB cable frequency is 6Mhz. In SP2 the default cable frequency is 6Mhz. Clocking at 24Mhz on XUP2VP board does not work reliably..
3. XMD command - connect mb mdm -type cable xilinx_platformUSB frequency 6000000. Or use the XPS GUI.

 -- Raj
 

> -----Original Message-----
> From: owner-microblaze-uclinux@itee.uq.edu.au 
> [mailto:owner-microblaze-uclinux@itee.uq.edu.au] On Behalf Of 
> adimbox-uclinux@yahoo.com.br
> Sent: Tuesday, August 23, 2005 9:39 AM
> To: microblaze-uclinux@itee.uq.edu.au
> Subject: [microblaze-uclinux] USB support with uClinux
> 
> Hello everybody !
> 
> I'm starting up a new project, using embedded linux. I have 
> an Altera board, and I saw in their forum that the USB 
> support is not fully functional.
> 
> So, I'm waiting for some new Digilent XUP2VP board to arrive, 
> and I'm gonna try uClinux with Microblaze processor. 
> 
> And how is the USB support in Microblaze/uClinux ? Is it 
> working fine, not working at all, or what ?
> 
> Regards.
> Arthur
> 
> 
> 	
> 	
> 		
> _______________________________________________________
> Yahoo! Acesso Grátis - Internet rápida e grátis. 
> Instale o discador agora! http://br.acesso.yahoo.com/ 
> ___________________________ microblaze-uclinux mailing list 
> microblaze-uclinux@itee.uq.edu.au Project Home Page : 
> http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
> Mailing List Archive : 
> http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/
> 
> 
> 


___________________________
microblaze-uclinux mailing list
microblaze-uclinux@itee.uq.edu.au
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/