[microblaze-uclinux] Re-connecting Ethernet after cable disconnect

["Jim Law" <jlaw@xxxxxxxxxxxxx>]

Hi all,

Things are bubbling along here - now firmly setup under VMWare and having 
fun with our NuHo S3-2000 board.

..... and there's always a 'but'......

If I disconnect the RJ45 Ethernet cable from the board, I get:

eth0: Duplex has been changed: now HALF_DUPLEX
eth0: Link carrier lost.

... not too bizarre.

But when I re-connect the cable, I don't seem to re-establish the Ethernet 
port (i.e. it no longer responds to pings, telnet, ftp, etc. from outside), 
even though an ifconfig reports all is well.

Any guidance or experience with this one?

Thanks,
Jim Law
Iris Power Engineering


___________________________
microblaze-uclinux mailing list
microblaze-uclinux@itee.uq.edu.au
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/