Re: Re: [microblaze-uclinux] creating uClinux kernel image

[<elynum@xxxxxxx>]

Thanks, I went back over the uClinux microblaze document and implemented everything got rid of that error but now it's telling me my spartan 3 starter fpga is too full.  I'm going to make sure I walked through everything correctly.  
> From: Jason Wu <wu@itee.uq.edu.au>
> Date: 2005/09/30 Fri AM 02:30:22 EDT
> To: microblaze-uclinux@itee.uq.edu.au
> Subject: Re: [microblaze-uclinux] creating uClinux kernel image
> 
> Hi Eric
> 
> >Thanks, Jason and John for your help.  Well I got the kernel image downloaded but trying to generate the BSP in EDK I get this error.  Any ideas?
> >  
> >
> So, does your kernel image build base on your microblaze platform?
> It may be a good idea that you could read through this tutorial. This 
> will give you some ideas.
> http://www.itee.uq.edu.au/~wu/downloads/uClinux_ready_Microblaze_design.pdf
> 
> >Running DRCs for OSes, Drivers and Libraries ... 
> >#--------------------------------------
> ># uClinux BSP DRC...!
> >#--------------------------------------
> >
> >Running generate for OS'es, Drivers and Libraries ... 
> >#--------------------------------------
> ># uClinux BSP generate...
> >#--------------------------------------
> >ERROR:MDT - ERROR FROM TCL:- uclinux () - expected integer but got ""
> >while executing
> >"format "0x%08x" $mem_start"
> >(procedure "do_memory_setup" line 49)
> >invoked from within
> >"do_memory_setup $config_file $os_handle "MAIN_MEMORY" CONFIG_XILINX_ERAM"
> >(procedure "::sw_uclinux_v1_00_a::generate" line 23)
> >invoked from within
> >"::sw_uclinux_v1_00_a::generate 37759808" 
> >Copying Library Files ...
> >ERROR:MDT - Error while running "generate" for processor microblaze_0...
> >make: *** [microblaze_0/lib/libxil.a] Error 2
> >Done.
> >  
> >
> I believe this cause by incorrect main_memory_bank value in Software 
> Platform Settings.
> The main_memory_bank value should corresponding to your main-memory's 
> C-NUM_BANKS_MEM value
> e.g if C-NUM_BANKS_MEM is '1', then the main_memory_bank should be '0'
> 
> Regards,
> 
> Jason
> 
> ___________________________
> microblaze-uclinux mailing list
> microblaze-uclinux@itee.uq.edu.au
> Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
> Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/
> 
> 

___________________________
microblaze-uclinux mailing list
microblaze-uclinux@itee.uq.edu.au
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/