RE: [microblaze-uclinux] xilinx sp305 board

["Wlovell" <wlovell@xxxxxxxxxxxxxxxxx>]

The SMSC 91C111, can be accessed as a memory device, so just use the EMC IP,
The Suzuka board uses the very same part. 

-----Original Message-----
From: Paul Hartke [mailto:phartke@xxxxxxxxxxxx] 
Sent: Thursday, December 29, 2005 14:09 PM
To: microblaze-uclinux@xxxxxxxxxxxxxx; e.stiebler
Cc: microblaze-uclinux@xxxxxxxxxxxxxx
Subject: Re: [microblaze-uclinux] xilinx sp305 board

I think you are on your own for the SMSC part.  That's the nice part about
the Xilinx IP Ethernet controller--it just works in Microblaze uclinux. 
While it might be conceptually nice to have the Ethernet MAC off chip, its
not clear to me what hardware IP would be used to access it.

Paul

Quoting "e.stiebler" <emu@xxxxxxxxxxx>:
> Paul Hartke wrote:
> > If the board supports EDK Base System Builder, then there is really
> nothing
> > to port--
>
> It is from Xilinx, so it should better support the EDK ;-)
>
> >it should just work.  Use Jason Wu's great tutorial on the webpage  
> >for the mechanics.  Even though it specifically targets ml401, there 
> >is  nothing that different for other boards.
>
> There is a small difference. Xilinx finally came to senses, and put 
> also an SMSC 91c111 Phy on it, so one doesn't need the Ethernet IP on it..
>
> Cheers
> ___________________________

___________________________
microblaze-uclinux mailing list
microblaze-uclinux@xxxxxxxxxxxxxx
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive :
http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/





___________________________
microblaze-uclinux mailing list
microblaze-uclinux@xxxxxxxxxxxxxx
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/