Re: [microblaze-uclinux] SystemACE mount on S3MB1500 fails

[Paul Hartke <phartke@xxxxxxxxxxxx>]

Did you format the Compact Flash device with mkdosfs?  See page 66 of
http://www.xilinx.com/univ/XUPV2P/Documentation/XUPV2P_User_Guide.pdf

Are you loading the bit file and kernel design from an acefile on the
Compact Flash device?

Paul

Quoting Marco Cavallini <arm.linux@xxxxxxxxxxxxxxxx>:
> > Did you enable MSDOS partition in the uclinux kernel config?
> > CONFIG_PARTITION_ADVANCED=y
> > CONFIG_MSDOS_PARTITION=y
>
> I completely ignored and forgotten to set such options, thank you ;-)
>
> After doing that,
> actually the problems starts earlier:
>
> .snip.
> Initializing SystemAce driver
> Partition check:
>  xsysacea: <3>JTAG controller couldn't read configuration from the
> CompactFlash
>  xsysacea1
> System ACE at 0x61000000 mapped to 0x61000000, irq=2, 31744KB
>
> I tried 3 different CFs, two hangs during boot at Partition check,
> and one reaches the login prompt.
>
> However mount command always freezed the system
> # mount -t msdos /dev/xsysacea1 /mnt
> [here is freezed]
>
> Any futher hints ?
> ciao
>
> /marco
>
___________________________
microblaze-uclinux mailing list
microblaze-uclinux@xxxxxxxxxxxxxx
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/