----- Original Message
----
From: elynum@xxxxxxx
To: microblaze-uclinux@xxxxxxxxxxxxxx
Cc: Nikhil Narayana <knikhil87@xxxxxxxxx>
Sent: Friday, June 16, 2006 7:07:42 AM
Subject: Re: [microblaze-uclinux] HELP!!! Porting UClinux on Spartan 3
You need more RAM to port
uclinux. I can't remember exactly the amount but you need much more
than 1MB.
---- Nikhil Narayana <knikhil87@xxxxxxxxx> wrote:
> Hi guys,
>
> I have been allocated a project in my university this summer. I am
supposed
> to port Uclinux on a Xilinx Spartan 3 FPGA Starter Kit Board (XC3S200).
The
> specs of this board are given below:
>
> 200,000 gates
> 2Mbit Platform Flash
> 1MB SRAM
> 9 pin RS 232 Serial Port
>
>
> Along with this I got the DVDs of Xilinx ISE Webpack and Xilinx EDK 8.1
and
> a computer on which I installed Fedora Core 3.
>
> Since, I had no prior experience with either FPGAs or Operating Systems I
> searched on the net for info and started following the guide by
Jason Wu &
> John Williams. I have downloaded the UClinux dist and 2.4.x as per the
> manual.
>
> As the manual is for ML 401 board I am having some doubts. The manual
states
> that I am to download the required MDM for V4 devices,dl.sh,Make file and
> xmd.ini Should I download these or not???? I would like to know that what
> changes am I supposed to make for Uclinux to run on my board??
>
> Also the manual specifies the changes to make in settings.sh for EDK 6.3
and
> EDK 7.1. I would like to know what changes are required in EDK
8.1???
>
> If anybody has ported Uclinux on this board please help me.
>
> Thanx in advance
>
> Nikhil
___________________________
microblaze-uclinux mailing list
microblaze-uclinux@xxxxxxxxxxxxxx
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/