RE: [microblaze-uclinux] Problem with compile uclinux kernel 2.4.x

["Pham Quoc Sang" <phamquocsang@xxxxxxxxxxxxxxx>]

Yes I have had a broken mb-gcc. I have downloaded again & it runs OK.
Thank you very much.

-----Original Message-----
From: owner-microblaze-uclinux@xxxxxxxxxxxxxx
[mailto:owner-microblaze-uclinux@xxxxxxxxxxxxxx] On Behalf Of John Williams
Sent: Thursday, November 16, 2006 1:02 PM
To: microblaze-uclinux@xxxxxxxxxxxxxx
Subject: Re: [microblaze-uclinux] Problem with compile uclinux kernel 2.4.x

Hi Pham,

Pham Quoc Sang wrote:

> I'm trying to compile uClinux for MicroBlaze on Spartan-3E starter kit. 
> After "make menuconfig" and "make dep" steps are success, the "make" 
> step generate following errors as below. B/c I am a very first compile 
> uClinux by mb-gcc, please tell me we is my troubles.
> 

> /tmp/ccdP1UDk.s: Assembler messages:
> /tmp/ccdP1UDk.s:695: Error: unknown pseudo-op: `.rodata'
> /tmp/ccdP1UDk.s:712: Error: unknown pseudo-op: `.rodata'
> /tmp/ccdP1UDk.s:730: Error: unknown pseudo-op: `.ent'

<snip>

Sounds like a broken mb-gcc.  what is the output of

$ which mb-gcc

and

$ mb-gcc -v

are you using the mb-gcc from petalogix.com, or that distributed with EDK?

Regards,

John


___________________________
microblaze-uclinux mailing list
microblaze-uclinux@xxxxxxxxxxxxxx
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive :
http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/



___________________________
microblaze-uclinux mailing list
microblaze-uclinux@xxxxxxxxxxxxxx
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/