[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[microblaze-uclinux] Thanks !

To: microblaze-uclinux@xxxxxxxxxxxxxx
Subject: [microblaze-uclinux] Thanks !
From: "Otto Blomqvist" <o2blom@xxxxxxxxx>
Date: Thu, 4 Jan 2007 22:05:48 -0800
Domainkey-signature: a=rsa-sha1; q=dns; c=nofws; s=beta; d=gmail.com; h=received:message-id:date:from:to:subject:mime-version:content-type; b=efc/oaPPRWBnZGMlzay8gKakXdXyLoScZ0n9xkcFxklKpGrqQo0Yt3BNoAvmBLzP0JnTPwNHAZCugwuqmcNXas9Yo0JtPENUCFOuJgGn2RXLjcJSfMJ2H20QOeqOj8B8DEwgCK8EDL1zWGYUmFaExYq/QNM5GpD/GrzQKOANVF4=
Reply-to: microblaze-uclinux@xxxxxxxxxxxxxx
Sender: owner-microblaze-uclinux@xxxxxxxxxxxxxx

Hi All !

Even though I am fairly green on Linux I followed the instructions on developer.petalogix.com and had no real problems. To be on the safe side I do run CentOS 3.0 . I built the Spartan 3E 8.2 Reference design board and it boots just fine. Everything is now burned to flash and I have a stand-alone running Petalogix.

Great success =)

I just wanted to say thank you to all the contributors that made this possible !

Next up - Get a SPI Master interface running

/Otto Blomqvist

PS. When using the serial upload the $(filesize) environmental variable does not get set (or was it $(fileaddr) hmmm)

Prev by Date: RE: [microblaze-uclinux] Determining the MAC address on a Spartan 3e Starter Kit
Next by Date: [microblaze-uclinux] Getting Started with microblaze-uclinux-gcc
Previous by thread: Re: [microblaze-uclinux] Howto access FSL with uClinux?
Next by thread: [microblaze-uclinux] Getting Started with microblaze-uclinux-gcc
Index(es):
- Date
- Thread