[microblaze-uclinux] uClinux on V4FX12

["Wright, Ron" <ron.wright@xxxxxxxxx>]

All,

  Are there any "gotchas" that would cause issues if I create a
MicroBlaze platform on a Memec V4FX12LC board, and then build and run a
uClinux kernel on it?

  I have a working kernel on the Xilinx Spartan3E kit, and I created a
very similar platform for the V4FX12LC, but after I export the
auto-config.in file and build the kernel (with identical selections to
the Spartan config), I get absolutely no output on download.  The only
obvious differences are that the processor is running at 100 MHz and the
DDR starts at 0x24000000 instead of 0x22000000.  Both differences should
be covered by the auto-config.in.

  Not sure where to start looking for a problem.

Ron

___________________________
microblaze-uclinux mailing list
microblaze-uclinux@xxxxxxxxxxxxxx
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/