RE: [microblaze-uclinux] Spartan3E board and u-boot question

["Leonid" <Leonid@xxxxxxxxx>]

Your srec file looks OK, u-boot will be downloaded to address
0x23fc0000. Thee can be many reasons why you don't see any output. One
of them is that u-boot's serial default baudrate is different from that
of fs-boot or you didn't import EDK compilation parameters to software
properly and clock and/or UART offset is different (check autoconf.h
file).

Leonid.

-----Original Message-----
From: owner-microblaze-uclinux@xxxxxxxxxxxxxx
[mailto:owner-microblaze-uclinux@xxxxxxxxxxxxxx] On Behalf Of Stephane
Rousseau
Sent: Friday, May 04, 2007 12:20 PM
To: microblaze-uclinux@xxxxxxxxxxxxxx
Subject: [microblaze-uclinux] Spartan3E board and u-boot question

Hi everyone,

Now, i'm able to build the hardware and compile for the Spartan3e-500
board.

I send the bit fit to the board,
see the FS-BOOT,
send the u-boot.srec file and see the running cursor

The following messages appear:

FS-BOOT: Warning image location differ from default boot location.
Image will not boot automatically after POR.

FS-BOOT: Press 'n' to boot old image.

FS-BOOT: Use new image.

FS-BOOT: Booting image...


I'm trying to figure the problem, is it the SDRAM, the u-boot
configuration problem?

The variable CONFIG_XILINK_ERAM_START is 0x22000000

And here are the two first lines of the u-boot.srec:

S00E0000752D626F6F742E73726563C0
S31523FC00009400C001B00023F6202000002021FFFC31

Does anyone had the same problem or an idea?

Thank you,

Stephane Rousseau
___________________________
microblaze-uclinux mailing list
microblaze-uclinux@xxxxxxxxxxxxxx
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive :
http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/


___________________________
microblaze-uclinux mailing list
microblaze-uclinux@xxxxxxxxxxxxxx
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/