[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [microblaze-uclinux] FS-BOOT keeps silent on 3E500 rev D

Hi Nicho,
 
It's likely you need to swap the serial connection, LCD design may use DCE and FS-boot one uses DTE, or vice versa.
 
Duy-Ky
 
From: owner-microblaze-uclinux@xxxxxxxxxxxxxx [mailto:owner-microblaze-uclinux@xxxxxxxxxxxxxx] On Behalf Of Nicho Johns
Sent: Saturday, September 08, 2007 5:09 AM
To: microblaze-uclinux@xxxxxxxxxxxxxx
Subject: Re: [microblaze-uclinux] FS-BOOT keeps silent on 3E500 rev D

As far as I can find in the archives, I always see people having no problem with FS-boot.
 
When I upload the prebuilt bitfile from the Xilinx Microblaze / LCD ref design, the device runs and I can see messages on the serial port.
With  the same configuration and whatever the Mode jumpers position, when I upload the prebuilt Spartan 3E500 Rev C bitfile, nothing happends.
 
Other jumpers are in default config.
 
I'm stucked !
 
Thanks for your help
Nicho

 
2007/9/7, e.stiebler <emu@xxxxxxxxxx>:
Nicho Johns wrote:
> I cannot have FS-BOOT running on my Spartan 3E500 Rev D even when using
> pre-built reference design.
> The board is OK as well as the serial connection when using Xilinx
> reference designs.
Check the archive, there should be a lot of discussion already about the
rev-d version.
But seeing that you can't even start the reference designs, I would
guess, that your mode jumpers are wrong.

> Any idea ?

what did you try already ?
___________________________
microblaze-uclinux mailing list
microblaze-uclinux@xxxxxxxxxxxxx
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/