Re: [microblaze-uclinux] No init found in booting message

[j.pfefferl@xxxxxxxxx (Dr. Johann Pfefferl)]

Hello,

possibly you have to increase the size of the allocatable memory block
size. If you configure a lot of tools inside busybox it is to large to
fit into a small memory layout system. At least this was the reason on
my system. I observed the same behaviour on my system.

Processor type and features  --->
     [*] Allow allocating large blocks (> 1MB) of memory

Hope this helps,
   Hans

victor-sv_yeo@xxxxxxxxxxx <victor-sv_yeo@xxxxxxxxxxx> wrote:
> Hi,
> 
>  
> 
> I am using Spartan-3E eval board. In make menuconfig, I select Xilinx as the vendor and Spartan3E500-RevC as the platform.
> 
>  
> 
> When I boot up the board, I get the following boot messages:
> 
>  
> 
> Unable to allocate RAM for process text/data, errno 12
> 
> Unable to allocate RAM for process text/data, errno 12
> 
> Kernel panic - not syncing: No init found. Try passing init= option to kernel.
> 
>  
> 
>  
> 
> What is the root cause? I have enabled init in the busybox. 
> 
>  
> 
> Rgds,
> 
> Victor Yeo
> 
>  
> 
>  
> 

-- 
Dr. Johann Pfefferl   ------------   mailto j.pfefferl at eubus dot net
Eubus GmbH            http://www.eubus.net +++++ http://www.hydraxc.com
Gollierstr. 70
D-80339 Muenchen
Phone: +49 (0)89 45 22 578-67     Fax: +49 (0)89 45 22 578-55
Registergericht Muenchen HRB 145 336, Ust-Id Nr. DE 225 783 933
Geschaeftsfuehrer: Volker Ulrich, Peter Sibities
==
 -o)   A computer program does what you tell it to do,
 /\\        not what you want it to do.               
_\_v-                                                 
___________________________
microblaze-uclinux mailing list
microblaze-uclinux@xxxxxxxxxxxxxx
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/