RE: [microblaze-uclinux] soft reset

["Yuan Song" <Yuan.Song@xxxxxxxxxxxxxxx>]

The vector 0 points to the uclinx reset handler which jumps to vector 0.  It
is just a loop.  Because bram is changed by uclinx.  I can not go back to my
bootloader anymore. 


Yuan

-----Original Message-----
From: owner-microblaze-uclinux@xxxxxxxxxxxxxx
[mailto:owner-microblaze-uclinux@xxxxxxxxxxxxxx] On Behalf Of Goran Bilski
Sent: Friday, March 14, 2008 3:18 PM
To: microblaze-uclinux@xxxxxxxxxxxxxx
Subject: RE: [microblaze-uclinux] soft reset

Hi,

You can use the reset signal on MicroBlaze itself or rather the
proc_sys_reset block which normally drives this reset signal.

A MicroBlaze reset will not clear the register file nor the caches (although
the caches will be disabled after reset).

Göran

-----Original Message-----
From: owner-microblaze-uclinux@xxxxxxxxxxxxxx
[mailto:owner-microblaze-uclinux@xxxxxxxxxxxxxx] On Behalf Of Yuan Song
Sent: Friday, March 14, 2008 8:42 AM
To: microblaze-uclinux@xxxxxxxxxxxxxx
Subject: [microblaze-uclinux] soft reset

Does anybody know how to reset the micrblaze board without reconfiguring the
fpga.   


Thanks,

Yuan


___________________________
microblaze-uclinux mailing list
microblaze-uclinux@xxxxxxxxxxxxxx
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive :
http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/




___________________________
microblaze-uclinux mailing list
microblaze-uclinux@xxxxxxxxxxxxxx
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive :
http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/




___________________________
microblaze-uclinux mailing list
microblaze-uclinux@xxxxxxxxxxxxxx
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/