[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: [microblaze-uclinux] Petalinux On Stpartan3E500
Hi
One more thing I observed is the "program start
address" in the "Environment" tab of "Compiler Options".
It is 0x70 in case of the reference
project.
I tried to build the referece project provided and use it
as it is.
I have observed the same thing with reference project
also.
ie. It just stops after showing "FS-BOOT: Booting image...".
Thanks
Mak
Hello,
I am trying to bring
up the Petalogix on the my Spartan 3E 500 board.
When I tried the
ready made download.bit file from Petalinux then it was working
fine.
But when I tried my
bit file it was not working.
I have added
following peripherals:
SDRAM, FLASH, GPIO
for LED's, Ethernet Lite, Timer and a UART DTE
terminal.
I have enabled
interrupts for the Ethernet, UART and Timer.
I have flashed the
image of UBoot (from Petalogix) at the start of the Flash
Memory.
When I download my
bit file and run the XMD, then I have seen that it is branched to the first
location of the flash.
The content is
0xb8b40008. According to documentation it is correct.
I can see the FS
bootloader's print messages on the Serial console. After showing "FS-BOOT:
Booting image..." it just stops there only.
I have
checked the compiler options of the fs bootloader. Those are
as mentioned in the FS bootloader's Documentation.
One more thing I
have checked which is size of BRAM, currently it is 16K. but checked changing
that also, it didn't worked out. I thought that may be the
problem.
Is there anything
that I have to extra while generating the bit file?
Regards,
Mak
Please
do not print this email unless it is absolutely necessary.
The information contained in this electronic message and any attachments to
this message are intended for the exclusive use of the addressee(s) and may
contain proprietary, confidential or privileged information. If you are not the
intended recipient, you should not disseminate, distribute or copy this e-mail.
Please notify the sender immediately and destroy all copies of this message and
any attachments.
WARNING: Computer viruses can be transmitted via email. The recipient should
check this email and any attachments for the presence of viruses. The company
accepts no liability for any damage caused by any virus transmitted by this
email.
www.wipro.com
Please do not print this email unless it is absolutely necessary.
The information contained in this electronic message and any attachments to this message are intended for the exclusive use of the addressee(s) and may contain proprietary, confidential or privileged information. If you are not the intended recipient, you should not disseminate, distribute or copy this e-mail. Please notify the sender immediately and destroy all copies of this message and any attachments.
WARNING: Computer viruses can be transmitted via email. The recipient should check this email and any attachments for the presence of viruses. The company accepts no liability for any damage caused by any virus transmitted by this email.
www.wipro.com