[microblaze-uclinux] Re: mONStR Uboot - Problems when I try to create my own board

["Juan Pablo Gómez " <juanwalker@xxxxxxxxx>]

Hi, thank you Michal. It work's correctly.. But the explanation could me more explicit for other people.. For example, the part where we inclued the lines in the makefile it's important to copy the tabs because withouth the tabs when we run make the makefile shows errors.

Also when you say that we have to
copy include/configs/ml401.h to mb_first.h

where exctly goes mb_first.h ?, It's seems that mb_frist.h has to be copied in  mb_boot root directory but when I checkout include/config.h I  rename this file in the same directory.

Otherwise, the make runs correctly.

Thank you for help me Michal

2008/10/17 Michal Simek <monstr@xxxxxxxxx>

Hi Juan Pablo,

there were small fault. Sorry for that. I wrote it from my mind.
I added some logs too. :-)
I have tested and work.

go to board/mb_first and rename ml401.c to mb_first.c (the name must be the same
as is name of board)

libmb_first is here

[monstr@xxxxxxxxx u-boot-denx-de]$ cd board/mb_first/
[monstr@xxxxxxxxx mb_first]$ ls
config.mk  libmb_first.a  Makefile  mb_first.c  mb_first.o  u-boot.lds
xparameters.h

Could you tested again?

Thanks,
Michal

Juan Pablo Gómez wrote:
> Greetings Michal I'm following the guide for use U-Boot
> (http://monstr.eu/wiki/doku.php?id=uboot:uboot)
>
> But when I try to create my own board I've this problem :
>
> make[1]: *** The no rule for build the objetive  `mb_first.o', necesary
> for  `libmb_first.a'.  Stop
>
> Perhaps there's any mistake on the section, after build de U-Boot I
> followed these steps for use a xupv2p  board :
>
> 1) copy this directory : board/xilinx/xupv2p   with this new name
> board/mb_first
>
> 2) copy this file include/configs/xupv2p.h with this name to
> include/configs/mb_first.h
>
> 3) change mb_first.h, the  include file (#include
> "../board/xilinx/ml401/xparameters.h") to #include
> "../../board/mb_first/xparameters.h"
>     The path in the wiki is correct  "../board/mb_first/xparameters.h" ?
>
> 4)  I edit the top level Makefile adding these lines
>
>
> mb_first_config:      unconfig
>       @mkdir -p $(obj)include
>       @echo "#define CONFIG_MB_FIRST 1" > $(obj)include/config.h
>
>       @$(MKCONFIG) -a $(@:_config=) microblaze microblaze mb_first
>
>
> It's seems that thw word FIRST was writed incorrectly, and don't forget
> the tab's.
>
> I followed these steps but the result was unsuccessful, waht I should do?
>
> Thank you Michal and regards, Juan Pablo
>
>
>

--
Muchas gracias.

Atentamente, Juan Pablo Gómez