[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [microblaze-uclinux] Getting started with uClinux on Digilent Spartan-3 board
Thanks for the advice but I already tried that and the Spartan-3 board
doesn't seem to be supported by the tools from petalogix.
On Wed, Feb 18, 2009 at 1:52 PM, Olof Backing <olof.backing@xxxxxxxxxxxx> wrote:
> On 18 feb 2009, at 11.44, Xavier Langellier wrote:
>
>> I'm new to uClinux on microblaze and I would like to get it running on a
>> Spartan-3 board.
>> First of all, is it possible to fit uClinux to the 1Mb RAM of this board.
>> I read the two answers, is it yes or no?
>> What is the preferred way to understand how to make uClinux work on
>> microblaze (some documentation), microblaze-uclinux or petalogix? Is there
>> already a port to this board, I can study to start?
>
>
> Go and have a look at developer.petalogix.com and give petalinux a try.
>
> Regards,
> Olof
> --
> Olof Backing
> CAG Contactor AB Office: +46 (0)8 752 81 00
> Finlandsgatan 14 Mobile: +46 (0)70 995 98 99
> SE-164 74 KISTA Fax: +46 (0)8 752 05 30
>
> ___________________________
> microblaze-uclinux mailing list
> microblaze-uclinux@xxxxxxxxxxxxxx
> Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
> Mailing List Archive :
> http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/
>
>
--
Xavier Langellier.
___________________________
microblaze-uclinux mailing list
microblaze-uclinux@xxxxxxxxxxxxxx
Project Home Page : http://www.itee.uq.edu.au/~jwilliams/mblaze-uclinux
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/microblaze-uclinux/