Re: [microblaze-uclinux] Porting Petalinux 0.20 Build -rc1 050607 to Digilent's XUPV2P board.

[Aws Ismail <aws.ismail@xxxxxxxxx>]

Thanks David for your reply. I am about to start porting it too so it's good to share the experience with anyone doing the same thing. I do have the SDRAM as a 256 MB DIMM on the board. What is your XUPV2P board revision?

Aws\

On Tue, Apr 28, 2009 at 9:25 PM, David Babich <dbabich@xxxxxxxxxxxxxxxx> wrote:

I actually just started working on a port for the Digilent XUPV2P board yesterday.  I'm doing it in my spare time, so my progress may be slow.  If I run into any issues I'll post as I go along.  Based on passed experience with Petalinux, it is certainly feasible and the XUPV2P is more than sufficient to support it provided you include the XUPV2P's SDRAM module in your design.

---

From: Aws Ismail (SFU) [mailto:aii@xxxxxx]
To: microblaze-uclinux@xxxxxxxxxxxxxx
Sent: Tue, 28 Apr 2009 19:15:05 -0600
Subject: [microblaze-uclinux] Porting Petalinux 0.20 Build -rc1 050607 to Digilent's XUPV2P board.

Hello Everyone,

I was wondering if anyone have tried porting Petalinux 0.20 Build rc1 to a Digilent XUPV2P board. If so, where there any problems or hurdles encountered. If not, is it even feasible?

I appreciate your input.

--
Aws Ismail, BASc. EE

MASc. Candidate
Mechatronic Systems Engineering
Simon Fraser University
250-13450 102 Avenue
Surrey BC V3T 0A3
---------

-- 
Aws Ismail, BASc. EE

MASc. Candidate
Mechatronic Systems Engineering
Simon Fraser University
250-13450 102 Avenue
Surrey BC V3T 0A3

Tel (Cell): 778-889-0526

---------