Re: [partial-reconfig] Strange XDL and FPGA_Editor Problem

[Will Hua Zheng <Hua.Zheng@xxxxxxxxxxxx>]

Umar Mushtaq wrote:

>Just when I was all set to try out the new macro, the tools strike
>back...
>
>Conversion from .nmc to .xdl is fine, but whenever I try to convert an
>.xdl file to .ncd, it instead creates a file that has an FPGA_Editor
>icon, and is listed as an "FPGA Editor Document"... however, it won't
>open in FPGA_Editor, not from the Command Prompt, not by double-clicking
>it and not by first opening the editor and choosing File>Open... I get
>an error saying (filename).ncd is not an ncd! Renaming it to .ncd or
>.nmc makes no difference since it doesn't change the file type, only the
>name...
>
>Whats strange about all this is just this morning I uploaded the macro
>and this entire process was working fine... 
>
>I vaguely recall facing this problem a few months back... unfortunately
>I don't remember what I did to fix it... Uninstalling and reinstalling
>the software hasn't helped...
>
>Any help would be welcome... I'm stalled here...
>
>:(
>
>Sincerely,
>Umar
>
>  
>
if you are on *nix try this:
mv (filename) (filename).ncd
if you are on windows try this:
move (filename) (filename).ncd

if all else fails, try to convert it back to xdl, if that still gives 
you errors, then it's not simply a file name problem.

-- 
WILL HUA ZHENG
3452 - TEST SYSTEMS ENGINEERING
JET PROPULSION LABORATORY
818-354-2974
Hua.Zheng@jpl.nasa.gov


___________________________
partial-reconfig mailing list
partial-reconfig@itee.uq.edu.au
Mailing List Archive : http://www.itee.uq.edu.au/~listarch/partial-reconfig/